|
|
11-24-2008
While lifting the tranny back in place, my shifter cable end broke at the bracket and near the end.
It looks like I need to replace the last for or five feet of this cable, as there's a connection at the firewall to another section of cable. Is this correct?
Can someone forward to me the part number? I can't find it in my parts breakdown, and I need to start looking for one.
regards,
Sean
'99 3.8l
11-24-2008
Yes these are typically a two piece cable and this is an adjustment point so it must be set up properly and there is a thread on here somewhere about how to do that. Contact Morad Parts Company and ask them for a cable, it will be much cheaper than a new one and they can likely just sell the half you need but a whole cable wouldnt be a bad idea just in case.
11-30-2008
Thanks for the lead on Morad. I ordered a cable. Just to verify: With the correct procedure I only need to remove the bottom half of the cable from the firewall? Or should I fish the entire cable thru (which I'd like to avoid if possible). thanks.
11-30-2008
You should only have to replace the end under the hood, just take the new cable apart if you ordered a complete one and attach it with your existing cable.
| « Previous Thread | Next Thread » |
| Tags for this Thread |
| Bookmarks |
Bookmarks |
