Activity Stream

Alright fellas , What is involved in swapping to a gen 5 on a gen 3 FSIC? Also i just ordered the Gen 3 north star adapter plate, can i make...

I was considering doing a 2.6 on my Gen 3 but said heck with it and got a Gen 5. Gives me a little more room to mod. Like Marshal said, going lower...

Y'know I bet they're oem mounts.

Awesome thread. I have two. I've had an electric Rustler 2wd for about 10 years, i think the only thing that's original is the chassis. ...

I figured they were pretty brittle. Unfortunately for me the lens is gone on mine. If I had the lens I could likely figure out a way to attach it....

As for being back, my interests tend to roam, i have 4 cars and each one of them is a project. 99 tahoe (1200 bucks) 2019 Mustang GT (Steeda...

on the grand prix i would totally agree about the catback, but the regal has a single exhaust. As for the Gen 5, what all is involved in...

I didn't notice any gains when I went from a 2.8 to a 2.6 with the gen 3. with your mods, you should really consider upgrading to a gen 5. one...

L to R. 3yo pos $30 rc, daughters new 2wd brushed stampede, twin detonator with a missing wheel and 20' range ruckus, new kyosho mad crusher nitro...

I have the Gen 3 SC, just want to make sure that any N* will work. I guess that means i will need to go to a 2.6 inch pulley or something at some...

Just get the adapter you need, either gen 3 or 5. Your trans will probably be fine if you don't beat on it. But it also could break. Mine has been...

Thanks guys. BTW - I'm good with a Calico as long as she gets me from A to B...and back to A. :D

Hey folks, Back again on another modding Binge. I have: Meth wideband o2 North star adapter kit All coming in the mail.

Still 5" of ground clearance

that low life......

What brand strut mounts?? Mine did the same with crap duralast mounts.

ive come across 3 pedal position sensors with glitches, all with over 110k miles driving. one of the two potentiometer circuits dies and the...

Unfortunately when it comes to diagnosing wiring issues and broken wires etc... I'm an literate so I may have to pay someone to figure this problem...

I do have a Cai I do have colder plugs 3 inch downpipe and I couldn't get a smaller pulley with the stage 1 tune but it comes with it stage 2 also I...

So you've confirmed that the fan does work when fed 12v. That's good. Next step would be confirming 12v at the plug when the fan is commanded to be...

So the relays didn't solve the problem. I had the original PCM so I swapped it in and that didn't solve the problem. I'm at a loss here on what it...

I have a 97 coupe also. The plastic on those lenses are So brittle now, it's nearly impossible not to break the tabs off the sides. I went to the...

I just took a look and it seems like i have space where scotty put his.

sounds like the TCC unlocking. Normal behavior for cruise control mode.

I went with a gen 5 blower, which you will notice has space for the nozzle, while the gen 3 doesn't. if you want to use methanol on a gen 3, just go...

I cleaned the original and kept it after it didn't seem to change anything. I then pulled one from an 04 at the local junkyard and cleaned that...